Epoxy Resin Kit ADR230

1. ARD 230 and ADH 230 resin and hardener are mixed 100:30 by weight. Mixing ration must be accurately measured, otherwise the resin may not dry/set properly. Pour the two components into a suitable mixing container, hardener first then resin.
2. Only mix the amount needed, within the pot life ( processing time). Calculate the volume required or use Resin Calculator.
3. Stir the measured quantity in the mixing container slowly and thoroughly for 3-5 minutes to ensure even consistency. Use a broad spatula and scrape the sides and bottom of the container as you stir. The mixture will heat up very slightly as it starts to react. This is a low Exotherm resin.
4. The maximum volume that can be poured in one go is 12 litres or 30mm (~1 inches) in one pour.
5. You may now have up to 10+ hours (at 20 °C, 500g mixed mass) to use the resin before it becomes too thick, as it gels and hardens.
   At this stage the resin can be poured into separate cups and colour pigments, pastes or tints added.
6. Your substrate (canvas/board/table/mold) must be dust-free, degreased and level.
   Pour the mixture or separate coloured mixtures onto the substrate. Resin is self-levelling and spreads by itself on a smooth, flat surface, although you can use a spatula to spread it.
   The resin can also be applied by brush or roller. Your work surface should be covered as and resin run-off or splatter will harden on it.
7. Should a new mix be applied onto cured resin layer, the contact surface should always sanded to improve adhesion.
8. Small mixing bubbles can be removed with the heat of a blowtorch or heatgun. Pass heat slowly and gradually over the resin surface in swivelling motion at a distance of approx. 10-30 cm above the resin surface. Do not overheat a single spot. If using alcohol inks DO NOT use a flame to remove the bubbles.
9. Protect the work from dust or other foreign objects by working in an environment that is as dust-free as possible. Cover the work when finished.
10. Cast can be removed from mold in 2-3 days, but full curing time is 60 hrs (2.5 days) at 20 °C. Clean the cured surface with a damp cloth.

IMPORTANT HEALTH & SAFETY

It is important to be proactive in safety measures.

• Wear disposable gloves when working with resin. Protect your hands throughout the whole process of measuring, mixing and application.
• We recommend that you wear a breathing mask/respirator when using ARD 230 and ADRH 230. This is especially important if you are working with materials such as fine pigments, pastes, spraypaint, solvents or alcohol inks.
• Work in well ventilated room.
• Wear respirator if sanding the cured resin product.
• Avoid skin contact (if there is contact, wash thoroughly with soap and water)
• Do not eat, drink or smoke while working with resin and pigments.
• See SDS and TDS for more on Health and Safety